Reasonable Aluminum Flat Mirror 25×25mm 5mm Thick λ/10

S-TFA-25S05-10

An economic general use mirror suitable for an illumination optical system and a simple experiments. It has the same reflectance and surface flatness as our aluminum mirrors (TFA) designed for use with a laser, but lower surface quality.
◦The dirt on the surface of the mirror can be wiped because the scratch-resistant protection is coated on the aluminum coating.
◦Reflectance of less variation can be obtained in a wide wavelength range from visible to near-infrared.
More Information
Name Reasonable Aluminum Flat Mirror 25×25mm 5mm Thick λ/10
Weight 0.0080kgs
Standard Coatings Available No
Guide -
Remark -
Attention
  • When a laser is transmitted with multiple mirrors installed, there will be loss of a large amount of light caused by the absorption of the aluminum coating. Please switch to dielectric multi-layer mirrors (TFM) for improved performance.
  • Reflectance specification is represented by the average of the reflectance of P polarized light and S polarized light. Reflectance may vary depending on the polarization state of the incident beam.
A x B 25mm x 25mm
Image Label Reasonable Aluminum Flat Mirror 25×25mm 5mm Thick λ/10
Rear Surface Ground
Reflectance Rave.>90%
Material BK7
Coating Al+MgF2
Parallelism <3′
Incident angle 45°
Laser Damage Threshold 0.25J/cm2 (Laser pulse width ; 10ns , Repetition frequency ; 20Hz)
Surface Quality (Scratch-Dig) 60-40
Diameter φD
Outer dimension A×B 25×25mm
Thickness t 5mm
Surface Flatness λ/10
Rear surface Ground
In stock
SKU
S-TFA-25S05-10
$37.00

Delivery in : 6-12 weeks

An economic general use mirror suitable for an illumination optical system and a simple experiments. It has the same reflectance and surface flatness as our aluminum mirrors (TFA) designed for use with a laser, but lower surface quality.

Resources & Downloads