Cover Plate for Cage Cube with M26.3 X 0.635 Screw Hole

C30-CB-CVP-M26.3

A cube-like joint in which rods are mounted in four directions.
It can fix the gimballed mirror holder with 4 rods passing through the cube.
◦ Mirror holders are supported by four (or three) rods (cages). In addition, the mirror holder can split the optical axis and the cage into two, or fold it to 90 degrees.
◦ The cage system has no distinction of up, down, left and right. Therefore, it is possible to place the holder in various orientations, which is convenient for constructing a three-dimensional optical system.



More Information
Name Cover Plate for Cage Cube with M26.3 X 0.635 Screw Hole
Weight 0.0410kgs
Guide ◦ Mirror holders are supported by four (or three) rods (cages). In addition, the mirror holder can split the optical axis and the cage into two, or fold it to 90 degrees.
◦ The cage system has no distinction of up, down, left and right. Therefore, it is possible to place the holder in various orientations, which is convenient for constructing a three-dimensional optical system.
Attention ▶ If the rod is tightened too tightly or if the tightening force is greatly different depending on the location, the rod may not fit in other holders.
▶ Initially fix the rod lightly, after building the optical system, please tighten so that the force that fixes the rod is even in each holder.
▶ When configuring a large optical system or a long optical system, it may become distorted or become unstable due to vibration.
Primary material Aluminum
Products Name Cover Plate for Cage Cube with M26.3 X 0.635 Screw Hole
Guide Rod Diameter (Spaceing between rod) φ6mm (30x30mm)
Compatible Mount C30-CB-H25.4
Compatiblefixing screw M26.3 P0.635
Installation Slide from the end of rods
In stock
SKU
C30-CB-CVP-M26.3
$37.00

Delivery in : 2 weeks

A cube-like joint in which rods are mounted in four directions.
It can fix the gimballed mirror holder with 4 rods passing through the cube.