Manual positioners

Guide

Linear Stages Guide

Stages used for positioning in X, Y and Z directions (in 3-dimensional plane).

Suitable for various purposes including optical experiments for research and development and assembly in systems.

Guide Structure

Crossed Roller Guide

Line contact of rollers in a V groove rail offers high stiffness.
In addition, low friction and almost no differential slip are suitable for minute feeding.

Features

Crossed roller guide enabled high precision and high stiffness.
Aluminum body offers light-weight.

Dovetail Slide Method

The dovetail groove method with face-fitting guide mechanism is used. Its high friction coefficient is not suitable for fine positioning, but very effective in simple positioning.

Features

The simple guide structure offers low price.
Highly stable due to face-fitting guide. Compact design is ideal for assembly in systems or fixing in confined spaces.

Ball Guide Method (TSD/TSDH/TSDT/TSDS Series)

These products are developed based on Sigma Koki’s original processing technology.

Features
  1. High Precision
  2. High Load Capacity
  3. High stiffness
  4. High Durability
  5. Low Profile
High Load Capacity and High Stiffness

The four-array contact structure achieves high load capacity and high stiffness (13 times stiffer than the V groove)

As shown in Fig-1, ball guides are machined across the arcs so that they have R groove structure and good contact with a ball allowing stable load capacity against the load in the directions where contact with the ball occurs frequently.

High Durability

Long life and free of maintenance

Fig-2 shows the pressure distribution of the R groove and the flat surface. As shown in the figure, pressure exerted on the R groove is dispersed and does not reach inside. Thus, metal fatigue and wear are reduced.

High Precision

The integral (simultaneous) machining achieves high precision
(straightness: 0.7 µm or lower)

As shown in Fig-3, the top and bottom plates are integrally and simultaneously machined using an originally devised machining jig to minimize respective machining errors. That is, to maintain high precision, these plates are machined in virtually the same state as when a ball is inside.

Low Profile

Reduction in the number of parts enables low profiling

Fig-4 shows a comparison of thickness of a crossed roller stage and a ball guide stage.
The integration of the guides into the top and bottom plates allows low profiling of the ball guide stage virtually the same state as when a ball is inside.

* The TSDT series further reduces the stage thickness to 10mm.

We detect that you are accessing the website from a different region. You will be redirected to a local version of OptoSigma.

Your requested the page :

EUROPE

Redirection to :