In stock
SKU
LCP
Compact and lightweight power meter for checking laser output that is small enough to fit into a pocket or tool kit.
Customize product
Filters
Enabled filters :
Remove all filters
Attention ▶Laser-shielding protective gear must be worn during use.
| Name | Wavelength Range | Delivery | Price | Add to cart | |||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
|
i
Laser Checker
LCP-33 |
400 - 1064nm |
1 week
|
€594.60
|
|
|
You must be logged in to ask questions
◦Press the Sample/Hold button to power on, center the laser beam on the sensor for two seconds or more while holding down the button. Release the button to see a measurement of the power.
◦It will automatically power off after 10 seconds when a measurement is completed.
◦Maximum power density is 30W/cm2 when the built-in ND attenuator is used, and 0.5W/cm2 when the attenuator is not used.
◦Sensor disk is made of silicon and has an 8mm aperture.
◦Battery life is 180,000 measurements at 12 sec/sample. The built-in lithium cell is not replaceable.
◦As overload warning, "---" will be displayed on the LCD screen with beep tone.
◦Microprocessor controlled with wavelength correction, auto-range (μW or mW), attenuator, power overload warning, and auto-stop functions.
◦It will automatically power off after 10 seconds when a measurement is completed.
◦Maximum power density is 30W/cm2 when the built-in ND attenuator is used, and 0.5W/cm2 when the attenuator is not used.
◦Sensor disk is made of silicon and has an 8mm aperture.
◦Battery life is 180,000 measurements at 12 sec/sample. The built-in lithium cell is not replaceable.
◦As overload warning, "---" will be displayed on the LCD screen with beep tone.
◦Microprocessor controlled with wavelength correction, auto-range (μW or mW), attenuator, power overload warning, and auto-stop functions.