Screw-on knobs, stainless steel, 14-mm diameter, M6×0.25 thread, pack of 3 ea.

MHX-K-M6

Higher moment of inertia to maximize stiffness and faster to reach thermal equilibrium characteristics are achieved by a hollow-frame design. Ideal for interference measurement or precision measurement.
Please check for an introduction video of the structure and features of MHX.
◦In the case of MHX-25.4F-R, Insert the mirror from the back and fix it when the mirror's reflective surface hits the mirror frame . As a result, the mounting center of the rod and the reflecting surface of the mirror can always be matched even if the thickness of the mirror changes.
◦MHX-25.4F/F-R has three adjustment screws to adjust not only tilt and rotation but also reflective surface the back and forth. The MHX-25.4A has only two adjustment screws to adjust only tilt and rotation.
◦Equipped with bonding holes for mirror bonding and pin holes for rotation prevention and positioning.
◦High-density stainless steel is used for the material, but the weight has been reduced by reducing the thickness.
◦The thickness of the frame is made thinner and follows immediately even if the temperature changes, and the distortion of the frame due to the temperature distribution is kept low.
More Information
Name Screw-on knobs, stainless steel, 14-mm diameter, M6×0.25 thread, pack of 3 ea.
Weight 0.0300kgs
Guide In addition, a special screwed knob (MHX-K-M6) is also available instead of the hexagon wrench.
  • A special lock (MHK-L-M6) for holding the adjusted angle is also available.
  • Attention
    • Cannot be mounted on M6 rod (RO). Use M4 or 8-32 UNC rods (ROC, RO-UU) when mounting a rod. It can be fixed to the post stand (PST) or the spacer with M4 tapped holes with M4 screws.
    • The reflecting surface of the mirror is located 4 mm deep from the front of the holder. There are 11mm offsets from the M4 screw fixing position.
    • When using a rod, it is not possible to change the beam transmission direction of the mirror holder. Use a post stand (PST) to change the direction.
    • When used with a cross beam (optical system such as a Michelson interferometer), the effective diameter of the beam becomes smaller.
    Material Stainless Steel
    Material Stainless Steel
    Knob Diameter 14mm
    Thread M6 x 0.250
    Knob Length 9mm
    Knurl Straight
    Reference Mark Arrow
    In stock
    SKU
    MHX-K-M6
    €14.10

    Delivery in : in stock

    Higher moment of inertia to maximize stiffness and faster to reach thermal equilibrium characteristics are achieved by a hollow-frame design. Ideal for interference measurement or precision measurement.
    Please check for an introduction video of the structure and features of MHX.

    Resources & Downloads

    We detect that you are accessing the website from a different region. You will be redirected to a local version of OptoSigma.

    Your requested the page :

    GERMANY

    Redirection to :