101.6-mm mirror mount, stainless steel, high-stability, front-loading, 2 hex adjusters

MHX-101.6A

Higher moment of inertia to maximize stiffness and faster to reach thermal equilibrium characteristics are achieved by a hollow-frame design. Ideal for interference measurement or precision measurement.
Please check for an introduction video of the structure and features of MHX.
MHX-F has three adjustment axes screws that allow the reflecting surface to be moved back and forth in addition to the adjustment of tilt and rotation. (MHX-A has only 2 axes of adjustment screws, so it can only be used for adjustment of tilt and rotation.
Adhesive holes for mirror adhesion and pin holes for anti-rotation and positioning are equipped.
High-density stainless steel is used for the material, but the weight has been reduced by reducing the thickness.
The frame design provides a higher moment of inertia to maximize stiffness and reduced-mass sections allowing it to reach thermal equilibrium faster for maximum stability.
More Information
Name 101.6-mm mirror mount, stainless steel, high-stability, front-loading, 2 hex adjusters
Weight 1.1300kgs
Guide In addition, a special screwed knob (MHX-K-M6) is also available instead of the hexagon wrench.
  • A special lock (MHK-L-M6) for holding the adjusted angle is also available.
  • Optic Loading Side Front Loading
    Angle Range ±2°
    Material Stainless Steel
    Number of Control Axes 2 points
    Optic Diameter φ101.6mm
    Mount Material Stainless Steel
    Compatible Optics Diameter 101.6mm (4 in.)
    Compatible Optics Thickness 10 - 20mm
    Mirror Loading Front
    Mirror Clamping Mechanism Set Screw with Torsion Barrier, 2-mm (5/64-in.) Hex Key
    Number of Adjustment Axes 2 points
    Angular Travel Range +/-2 Deg
    Linear Travel Range N/A
    Adjuster Thread M6 x 0.250mm (~100 TPI)
    Standardized Adjustment Sensitivity (based on 1 deg. knob rotation) 13 μrad
    Typical Adjustment Sensitivity 2 +/-1 urad
    Dowel Pin Keys 2mm Slot and Hole
    Standard Mounting Clearance hole for M6 / 1/4-20 screws
    Center-Post Mounting M6 and 1/4-20 threaded holes
    Out of stock
    SKU
    MHX-101.6A
    €886.30
    Higher moment of inertia to maximize stiffness and faster to reach thermal equilibrium characteristics are achieved by a hollow-frame design. Ideal for interference measurement or precision measurement.
    Please check for an introduction video of the structure and features of MHX.

    We detect that you are accessing the website from a different region. You will be redirected to a local version of OptoSigma.

    Your requested the page :

    GERMANY

    Redirection to :